PubAg

Main content area

Adsorption behavior of large plasmids on the anion-exchange methacrylate monolithic columns

Author:
Krajnc, Nika Lendero, Smrekar, Franc, Štrancar, Aleš, Podgornik, Aleš
Source:
Journal of chromatography 2011 v.1218 no.17 pp. 2413-2424
ISSN:
0021-9673
Subject:
adsorption, anion exchange, binding capacity, chromatography, ionic strength, plasmids, salt concentration, sodium chloride
Abstract:
The objective of this study was to investigate the behavior of large plasmids on the monolithic columns under binding and nonbinding conditions. The pressure drop measurements under nonbinding conditions demonstrated that the flow velocities under which plasmid passing monolith became hindered by the monolithic pore structure depended on the plasmid size as well as on the average monolith pore size; however, they were all very high exceeding the values encountered when applying CIM monolithic columns at their maximal flow rate. The impact of the ligand density and the salt concentration in loading buffer on binding capacity of the monolith for different sized plasmids was examined. For all plasmids the increase of dynamic binding capacity with the increase of salt concentration in the loading solution was observed reaching maximum of 7.1mg/mL at 0.4M NaCl for 21kbp, 12.0mg/mL at 0.4M NaCl for 39.4kbp and 8.4mg/mL at 0.5M NaCl for 62.1kbp. Analysis of the pressure drop data measured on the monolithic column during plasmid loading revealed different patterns of plasmid binding to the surface, showing “car-parking problem” phenomena under certain conditions. In addition, layer thickness of adsorbed plasmid was estimated and at maximal dynamic binding capacity it matched calculated plasmid radius of gyration. Finally, it was found that the adsorbed plasmid layer acts similarly as the grafted layer responding to changes in solution's ionic strength as well as mobile phase flow rate and that the density of plasmid layer depends on the plasmid size and also loading conditions.
Agid:
291828