U.S. flag

An official website of the United States government

PubAg

Main content area

Combined Lint Cleaning System PM10 Emission Factors and Rates for Cotton Gins: Method 201A PM10 Sizing Cyclones

Author:
Boykin, J. Clif, Buser, Michael D., Whitelock, Derek P., Holt, Gregory A.
Source:
Journal of cotton science 2014 v.18 no.2 pp. 248-257
ISSN:
1524-3303
Subject:
exhaust systems, cyclone separators, lint cotton, industry, data collection, emissions factor, particulates, particulate emissions, air flow, cleaning, agricultural machinery and equipment, cleaning equipment
Abstract:
This report is part of a project to characterize cotton gin emissions from the standpoint of stack sampling. The impetus behind this project was the urgent need to collect additional cotton gin emissions data to address current regulatory issues. A key component of this study was focused on EPA emission factors for particulate matter with a particle diameter nominally less than or equal to 10 μm (PM10). The 1996 EPA AP-42 emission factors were assigned quality ratings, from A (Excellent) to E (Poor), to assess the quality of the data being referenced. Emission factor quality ratings for cotton gins were extremely low. Cotton gin data received these low ratings because they were collected almost exclusively from a single geographical region. The objective of this study was to collect additional PM10 emission factor data for combined lint cleaning systems at cotton gins located in regions across the cotton belt based on EPA-approved stack sampling methodology, Method 201A. The project plan included sampling seven cotton gins across the cotton belt. Key factors for selecting specific cotton gins included: 1) facility location, 2) production capacity, 3) processing systems and 4) abatement technologies. Three of the seven gins had 1st and 2nd stage lint cleaning systems where the exhaust airstreams were combined. In terms of capacity, the three gins were typical of the industry, averaging 28.0 bales/h during testing. Some test runs, included in the analyses, had cotton lint fibers that collected in the ≤ 10 μm samples. This larger lint material can affect the reported emissions data, but EPA Method 201A does not suggest methods to account for these anomalies. The combined lint cleaning system average emission factors for PM10 and total particulate were 0.150 kg/227-kg bale (0.332 lb/500-lb bale) and 0.293 kg/bale (0.647 lb/bale), respectively. System average PM10 and total particulate emission factors were higher than those currently published in EPA AP-42. The combined lint cleaning system PM10 emission rate test averages ranged from 1.62 to 5.19 kg/h (3.56-11.45 lb/h). The ratio of combined lint cleaning system PM10 to total particulate was 51.3%.
Agid:
60287
Handle:
10113/60287