PubAg

Main content area

GIS based analysis of doline density on Taurus Mountains, Turkey

Author:
Öztürk, Muhammed Zeynel, Şimşek, Mesut, Şener, Mehmet Furkan, Utlu, Mustafa
Source:
Environmental earth sciences 2018 v.77 no.14 pp. 536
ISSN:
1866-6280
Subject:
geographic information systems, limestone, mountains, tectonics, topographic maps, treeline, Turkey (country)
Abstract:
The Taurus Mountain is one of the most important karstic region of the world and dolines are characteristics landforms of this area. However, the number and distribution of doline are unknown in the study area. The aims of this study are to explain the total number of dolines, distribution of doline density, effects of slope conditions and the change of doline orientation in the Taurus Mountains. According to the 1/25000 scale topographic maps utilized in this study, a total of 140,070 dolines were determined in a 13,189 km² area on eleven high karstic plateaus bordered by steep slopes and deep gorges. These plateaus are substantially affected by highly-faulted and jointed systems and about 80% of each plateau is covered with neritic limestone. The dolines are located at an elevation between 10 and 2870 m. Average elevation of all dolines is 1842 m. 90% of dolines are located between 1300 and 2270 m and only 5% of dolines found under 1330 m. According to this results, the densest doline zone corresponds to the alpine and periglacial zone above the treeline. Doline density reaches > 100 doline/km² on Mt. Anamas and the Seyran, Geyik and Akdağ ranges as well as the Taşeli plateau. Maximum density (187 doline/km²) is found on the Akdağ Mountains. However, 66% of the study area is characterized by low density, 29.9% with moderate density, 3.4% with high density and 0.7% with very high density. The highest doline densities are seen on gentle slopes (15°–25°/km²) and steep slopes (> 35°/km²) are limited doline distribution. According to the rose diagram formed by the azimuths of the long axis of the dolines at the Central Taurus, two direction are dominant in doline orientations (NW–SE and NE–SW). However, dominant directions are NE-SW at eastern, NE–SW and NW–SE at central and NW-SE at western part of the Central Taurus. According to this elongations, doline orientations are formed an arc which is formed by tectonic evolution of the Central Taurus.
Agid:
6039798