U.S. flag

An official website of the United States government


Main content area

Third stage seed-cotton cleaning system particulate emission factors for cotton gins: Particle size distribution characteristics

Buser, Michael D., Whitelock, Derek P., Boykin, J. Clif, Holt, Gregory A.
Journal of cotton science 2015 v.19 no.3 pp. 415-426
air quality, cleaning, cotton gin, emissions factor, particle size, particle size distribution, particulate emissions, particulates, seed cotton, United States
This report is part of a project to characterize cotton gin emissions from the standpoint of total particulate stack sampling and particle size analyses. In 2006 and again in 2013, the United States (U.S.) Environmental Protection Agency (EPA) published a more stringent National Ambient Air Quality Standard for particulate matter with nominal diameter less than or equal to 2.5 µm (PM(2.5)). This created an urgent need to collect additional cotton gin emissions data to address current regulatory issues, because EPA AP-42 cotton gin PM2.5 emission factors were limited. In addition, current EPA AP-42 emission factor quality ratings for cotton gin PM10 (particulate matter with nominal diameter less than or equal to 10 µm) data are questionable, being extremely low. The objective of this study was to characterize particulate emissions for 3rd stage seed-cotton cleaning systems from cotton gins across the cotton belt based on particle size distribution analysis of total particulate samples from EPA-approved stack sampling methods. Average measured PM(2.5), PM(6), and PM(10) emission factors based on the mass and particle size analyses of EPA Method 17 total particulate filter and wash samples from two gins (5 total test runs) were 0.00090 kg/227-kg bale (0.0020 lb/500-lb bale), 0.0075 kg/bale (0.017 lb/bale), and 0.012 kg/bale (0.027 lb/bale), respectively. The 3rd stage seed-cotton cleaning system particle size distributions were characterized by an average mass median diameter of 9.6 µm (aerodynamic equivalent diameter). Based on system average emission factors, the ratio of PM(2.5) to total particulate was 3.84%, PM6 to total particulate was 32.2%, and PM10 to total particulate was 51.5%.