U.S. flag

An official website of the United States government

PubAg

Main content area

Combined mote system particulate emission factors for cotton gins: Particle size distribution characteristics

Author:
Boykin, J. Clif, Buser, Michael D., Whitelock, Derek P., Holt, Gregory A.
Source:
Journal of cotton science 2015 v.19 no.3 pp. 517-528
ISSN:
1524-3303
Subject:
air quality, cotton, cotton gin, emissions factor, particle size, particle size distribution, particulate emissions, particulates, United States
Abstract:
This report is part of a project to characterize cotton gin emissions from the standpoint of total particulate stack sampling and particle size analyses. In 2006 and again in 2013, the United States (U.S.) Environmental Protection Agency (EPA) published a more stringent National Ambient Air Quality Standard for particulate matter with nominal diameter less than or equal to 2.5 µm (PM(2.5)). This created an urgent need to collect additional cotton gin emissions data to address current regulatory issues, because EPA AP-42 cotton gin PM(2.5) emission factors were limited. In addition, current EPA AP-42 emission factor quality ratings for cotton gin PM(10) (particulate matter with nominal diameter less than or equal to 10 µm) data are questionable, being extremely low. The objective of this study was to characterize particulate emissions for combined mote systems from cotton gins across the cotton belt based on particle size distribution analysis of total particulate samples from EPA approved stack sampling methods. Average measured PM(2.5), PM(6), and PM(10) emission factors based on the mass and particle size analyses of EPA Method 17 total particulate filter and wash samples from two gins (six total test runs) were 0.0026 kg/227-kg bale (0.0056 lb/500-lb bale), 0.030 kg/bale (0.065 lb/bale), and 0.052 kg/bale (0.115 lb/bale), respectively. The combined mote system particle size distributions were characterized by an average mass median diameter of 15.8 µm (aerodynamic equivalent diameter). Based on system average emission factors, the ratio of PM(2.5) to total particulate was 1.75%, PM(6) to total particulate was 20.4%, and PM(10) to total particulate was 35.7%.
Agid:
61752
Handle:
10113/61752